Electrical Terminal Crimping Machine(1.5-5.0T)

● Industrial control panels & MCC wiring

The 1.5T–3T variants cover the insulated ring terminals and ferrules used on control panel DIN rail wiring (0.5–6mm²), where bench-top deployment and fast applicator changeover are priorities.

● Automotive wire harness assembly

The 2T–4T grades handle the open-barrel connector terminals used in body, powertrain, and sensor sub-harnesses, accepting both single loose contacts and continuous terminal reels without tooling changes.

● Home appliances & industrial electronics

Power supply lead termination, motor connection tabs, and grounding lug assemblies in appliance production lines typically fall within the 2T–5T operating range of the EW-09 series.

● EV charging equipment & energy storage

Control and communication cable termination in EV charging stations and battery management systems requires consistent crimp quality at the 3T–5T range — achievable with the EW-09D through EW-09F variants.

Q: What crimping force range does the EW-09 terminal crimping machine series cover?

A: The EW-09 series spans five models: EW-09B at 1.5T (15KN), EW-09C at 2T (20KN), EW-09D at 3T (30KN), EW-09E at 4T (40KN), and EW-09F at 5T (42KN). Motor power ranges from 0.55KW to 1.8KW and machine weight from 35kg to 73kg across the range.

Q: What terminal types is this machine compatible with?

A: It is compatible with DC terminals, AC terminals, single loose terminals, and continuous reel-fed terminals, using 30mm or 40mm stroke applicators depending on the terminal series. This covers the majority of open-barrel and insulated terminal types used in automotive, industrial, and appliance wiring applications.

Q: What does frequency conversion technology mean for a terminal crimping machine?

A: A frequency conversion (variable frequency drive) system adjusts motor speed to match the actual load of each crimp cycle instead of running at fixed full speed. For terminal crimping this means lower energy consumption during idle phases and more precise ram positioning at stroke end — which directly reduces crimp height variation across a production run compared to fixed-speed motor presses.

Q: Can the stroke length be changed to suit different applicator tooling?

A: Yes. All EW-09 variants accept both 30mm and 40mm stroke applicators, which covers the two standard stroke lengths used by the majority of terminal applicator manufacturers. Stroke selection is made at the applicator level, not the machine level, so switching between terminal series requires only an applicator change rather than a machine change.